wpd84c1068.gif
HomeProductsNewsSupportContactsAbout
Euro Plates
One Gang Plates
Euro Plates
Stainless Steel Plates
 

DADO-1G-SS
DADO-1G-J-SS
DADO-1G-P-SS
DADO-2G-P-SS
DADO-2G-90P-SS
DADO-2G-J-SS
DADO-2G-90J-SS
DADO-1G-AB-SS
DADO-2G-AB-SS
DADO-2G-AD-SS
DPA-40
DADO-STA

Active Plates
 

DADO-1G-AB
DADO-2G-AB
DADO-2G-AD
EP-AB50-ST
DPA-40
EPA-41
SPC 4
SPC 6
SPC 7

WhiteBoard Plates PA VA

 

DPA-40

DPA-40B
DPA40 Black

DPA-40W
DPA40 white

DPA-40S
DPA-40

Normally supplied with UK supply add "EU" to order code for European supply.

The Ikon DPA-40 is a 20 watt stereo wall and dado mounting amplifier. It is ideal for multi-room audio, classroom, hotel bedroom and small meeting room applications.

Available in brushed stainless steel and a flat white or black finish, the DPA-40 fits a standard UK format double back box and requires only a 35mm depth.

The DPA-40 uses an 86% efficient class D design and has a RMS output of 20 watts per channel into 8 Ohms, and as most quality loudspeakers are 8 Ohms, maximum efficiency is assured. Additionally the amplifier also has remote shutdown ability adopting an ultra low power standby state.

It is fitted with screw terminals for power, speakers & inputs on the rear for permanent connections and a 3.5mm stereo jack on the front panel for other sources making the DPA-40 easy to install & use.
Unique features of the DPA-40 are the selection of three alternative RMS output powers as well as a 4 Ohm mono (single channel) mode.

RMS Output Power

Power

Stereo, Per Channel

Mono

Supply

Into 8 Ohms

4 Ohms

18V

20 watts

40 watts

15V

14 watts

28 watts

12V

10 watts

18 watts

Specification

Power Output , 12V Stereo Mode
10W RMS* per channel into 8 Ohms
Power Output , 18V Stereo Mode
20W RMS* per channel into 8 Ohms
Power Output , 12V Mono mode
20W RMS* into 4 Ohms
Power Output , 18V Mono mode
40W RMS* into 4 Ohms
Bandwidth
20Hz to 22KHz +/- 1dB
THD & Noise
<0.8%
S/N Ratio
76dB
Gain
26dBu
Coupling
Input: AC; Output DC.
Minimum input for full power
-6dB
Protection
Integral, auto resetting, current limit
& thermal protection.
Integrated click & pop suppression.
Power Source
12V DC @ 2.5A ( supplied ) or 18V DC @ 3.5A
Power Connector
2.1mm DC connector, centre
No signal current (12V)
28mA
Standby current (12V)
10mA
* The EPA-41 is a class D switching amplifier so the RMS values are RMS equivalent, this is that they give the same Sound Pressure Level using music or speech from a loudspeaker as a linear amplifier delivering the quoted RMS level.

Downloads

Operating Manual
Leaflet Sales literature